Seiko 6217-8000

And yet another 62mas is featured today, but not any old 62mas – this is a rather special one. I picked up the watch a while ago and it has been sitting in the project drawer for some time now whilst I a) decided what to do with it, and b) actually arranged my schedule so I could get on with it. As you can see the watch wasn’t in too bad a condition when it arrived, it was minus an insert but complete. A yobokies insert was purchased and that was fitted before this shot was taken.

P1010137a (more…)

Seiko 6217-8001

I’ve previously featured a 62mas where I said it’s one of my favourite vintage Japanese dive watches, so there’s no apologies for featuring another. This example came in for a movement service and was in pretty good shape considering the age. The hands are missing because it came to me via James Hyman who’d already relumed the dial and handset, there’s no point putting the hands back on if they’re coming straight off again!

P1010975a (more…)

Another 62mas saved

I make no apologies for the fact that the Seiko 62mas is my favourite vintage Japanese dive watch. For me, the case size at 37mm is perfect and the design is a classic. I’ve owned every variant and restored many more of these beauties so when I was offered a case, bezel and dial I thought they would be fine for spares at the least. When it all arrived the case had no tube so was essentially useless and the dial had no feet! The bezel was a nice example though. Well these parts were put in stock and I thought no more about it. As time went by I picked up a spare 6217a movement complete with the case ring and some NOS crowns, stems and crystals. In the mean time I was contacted by a friend of mine who mentioned he was actively looking for a 62mas diver and did I know any for sale? I remember I had this project tucked away so I said if he hadn’t found one by the time this was finished he could take it if he liked. This gave me renewed interest in the project and when I revisited the case I realised I had enough parts for a complete watch if it wasn’t for the missing case tube that had been butchered out. I thought I’d have a go at fitting a generic tube of the correct dimensions, after all I had nothing to lose! I reamed out the hole in the case to the size of a suitable tube, however there were still some rough spots in the hole that I couldn’t remove as the diameter would have ended up too large. Although the tube pressed in nicely I decided to smear some slow curing two part epoxy around the inside of the hole and on the tube to prevent the possibility of any moisture ingress. The pictures start here, I didn’t take any earlier ones because in my mind at that time they were essentially just spare parts!

Here is the new tube in place in the case.

DSCN7021a (more…)